• DocMcStuffin@lemmy.world
            link
            fedilink
            arrow-up
            6
            ·
            8 months ago

            After digging through the rule the NHTSA adopted, there’s nothing in there that mandates side glazed windows. The rule covers ejection mitigation. The summary hits the major point:

            The agency anticipates that manufacturers will meet the standard by modifying existing side impact air bag curtains, and possibly supplementing them with advanced glazing. The curtains will be made larger so that they cover more of the window opening, made more robust to remain inflated longer, and made to deploy in both side impacts and in rollovers. In addition, after deployment the curtains will be tethered near the base of the vehicle’s pillars or otherwise designed to keep the impactor within the boundaries established by the performance test. This final rule adopts a phase-in of the new requirements, starting September 1, 2013.

            There’s a lot of discussion in there. The document is over 300 pages. Some of it covers how the side windows can be down or could become deformed from a roll-over. For testing procedures the windows have to be pre-cracked or removed.

            The Federal Registrar calls out side glazed windows in 49 CFR 571.226:

            S1. Purpose and Scope. This standard establishes requirements for ejection mitigation systems to reduce the likelihood of complete and partial ejections of vehicle occupants through side windows during rollovers or side impact events.

            and in 49 CFR 571.226 S4.2.1.1:

            S4.2.1.1 No vehicle shall use movable glazing as the sole means of meeting the displacement limit of S4.2.1.

            I anticipate that mid to higher end vehicles will have side glazed windows. While lower end vehicles will not.

          • perviouslyiner@lemmy.world
            link
            fedilink
            arrow-up
            5
            ·
            8 months ago

            Apparently it was because people’s arms (or even heads?) would hang out of the broken window when a car is rolling over at highway speeds.

      • BrianTheeBiscuiteer@lemmy.world
        link
        fedilink
        arrow-up
        7
        ·
        8 months ago

        If I remember the MythBusters episode your only other options are to roll down the windows immediately and then start to exit or wait for the car to completely submerge and hope the electronics that control your windows and doors haven’t failed.

    • eran_morad@lemmy.world
      link
      fedilink
      arrow-up
      23
      arrow-down
      5
      ·
      8 months ago

      My car’s headrests have a glass breaker tip at the bottom of the metal bars that you use to raise/lower them. I imagine this is standard in many modern-ish cars.

        • ShadowRam@kbin.social
          link
          fedilink
          arrow-up
          18
          arrow-down
          1
          ·
          8 months ago

          WTF, how can they just make a change like that, and it get approved to be on the road?

          Youtube comment,

          Tesla that crashed into a pole, it was on fire, and the driver was trapped behind the laminated glass. Scary situation.

          The first in crew that responded had a firefighter try to break the glass with a conventional window punch device, that didn’t work.

          Then he tried smashing it with some forcible entry tools, that didn’t work either.

          The driver ended up dying. It took 45 mins to extinguish the flames and 15 mins to get the car doors open.

      • Plague_Doctor@lemmy.world
        link
        fedilink
        arrow-up
        17
        arrow-down
        2
        ·
        8 months ago

        Apparently not in door gap, trunk lid pours water into car, discharged battery can’t open rear passenger doors, Teslas.

      • Cornpop@lemmy.world
        link
        fedilink
        English
        arrow-up
        16
        arrow-down
        5
        ·
        8 months ago

        Those aren’t glass breakers, and you probably can’t shatter the glass with those. Car windows are incredibly strong.

          • givesomefucks@lemmy.world
            link
            fedilink
            English
            arrow-up
            8
            arrow-down
            4
            ·
            8 months ago

            Yeah, but it’s way harder under water.

            I punched a window and broke it back in the day, but that was a junk car from the 80s we were destroying. And I was outside of it with all the room in the world.

            Trying to do it while seated inside would have been impossible, and underwater all that pressure against the other side spread out equally makes it really umpossible. It’s basically a giant cushion that absorbs and distributes the force. If you do break it, all that water pressure is going to push it straight in your face, and chances are you’re just going to let the water in, but not create a whole big enough to climb thru. Certainly not u til your car is full of water and pressure equalizes.

            If you’re worried about this enough to carry a glass breaker, take a page from the Kia boys and make sure it’s ceramic. Even steel with a point is going to be difficult. But ceramic will shatter it with almost no effort. Gotta keep on bipping